Stripping In Dyeing

Process Flow Chart Of Stripping In Dyeing 

Cotton Knit Fabric Re-Process 

Knit Dyeing is a critical procedure and it is required to match the shade of the dyed fabric with the buyer’s approved swatch. Sometimes, it is found that the dyed fabric shade does not match with the approved swatch then this fabric is required to re dyeing. This re dyeing process is called stripping. Most of the time, black shade or deep shade is produced by the stripping process. Topping is another re dyeing process but stripping and topping is use for different case. Stripping sequence of knit cotton fabric: Reactive dyes dyeing process is done for cotton or cellulosic fiber. Here, I have given a stripping process for the cotton fabric. 

 Fabric received from the batching section 

↓ 

Required amount of water was taken into the machine 

↓

The fabric was loaded and run for 5-10 minutes in normal temperature ↓ Wetting agent, anticreasing agent were added at a time for 5 minutes 

↓ 

Caustic was dosing at normal temperature for 5 minutes 

↓ 

Run for 10 min. 

↓ 

Temperature increase at 1100C and continue for 40 min. ↓ Cooling at 800C ↓ Hydrose inject for 5 min. 

↓ 

Temperature increased at 1100C for 10 min. ↓ Run for 30 min. ↓ Cooling at 800C ↓ Sample check ↓ Rinsing for 15 min. ↓ 

Hot wash 

↓ 

Cold Wash ↓ Unload the Fabric Stripping is done on the dyed fabric for this reason this type of re-dyeing increases the cost of the dyeing process.

• Process Sequence Of Removal Softener Spots From The Dyed Fabric

• Process Sequence Of Topping For Cotton fabric | Dyes Adding Process

• Bleaching And Scouring Process Of Grey Melange Fabric

• Process Flow Chart Of Viscose Fabric Dyeing

• Dyeing Procedure Of Polyester Fabric | Disperse Dyeing Process